Time Log Switch Tansun for infrared heaters 4,0kW

The Tansun time lag switch is ideal for saving energy and gaining control of exterior heaters. They are fully IP66 rated and will turn on the heater for a pre-determined period of time from 2 to 20 minutes.

• Ideal for energy saving control of exterior heaters and exterior lighting. Also suitable for damp areas indoors. Adjustable 2 to 20 minutes.
• Pressing the touch sensitive area brings the connected load on. The load is then switched off automatically after the time lag has elapsed.
• Illuminated touch area for easy location in the dark.
• Tough, hard wearing, IP66 rated polycarbonate moulding.

Ideal for:

Smoking Shelters, Bars, Restaurants and anywhere that requires controlled heat and lighting.

Technical specification:

• Load at 230 Vac ~ 50/60Hz: Maximum of 4000W
• Dimensions (mm): 120 x 90 x 60mm

Installation procedure:

1. Please read these notes carefully before commencing work. In case of doubt please consult a qualified electrician. Make sure the power is isolated from the circuit.
2. The TAN16AEXT should be connected as shown opposite. L Brown Live in N Blue Neutral in SL Orange Switched line out E Yellow/green Earth (two earth terminals are supplied)
3. Typical wiring diagram is shown opposite.
4. To ensure an IP66 rating, mount the enclosure using only the four fixing holes provided, use a circular cable of diameter 6­12mm, fit the seal provided into the groove within the enclosure lid. If the IP66 rating cannot be achieved then the drain­hole guide on the lower face of box should be carefully drilled through with 4mm drill to a maximum depth of 10mm, enabling IP54.
5. The time lag is adjusted via a spindle located within the product.
6. When wiring has been completed and verified, switch on supply and test operation.
7. The first time the TAN16AEXT is activated after the power has been restored to the unit, it will switch the load on for just 10 seconds.